Baldor 22H series Installation & Operating Manual page 42

Section 1
General Information
Programmable 0–5V Output (Factory Preset: Speed)
Note 1
Programmable 0–5V Output (Factory Preset: Current)
Both CLOSED= Forward
Both OPEN = Stop
* All CLOSED= Fault Reset
Notes:
1. Refer to Analog Outputs.
2. Refer to Opto Isolated Outputs.
3. Refer to Encoder Installation.
4. Refer to Buffered Encoder Output.
*
Refer to truth table, Table 3-9.
MN722
Figure 3-13 15 Speed 2-Wire Control Connection Diagram
No Connections
Refer to Figure 3-23.
Note 2
J1-8 OPEN disables the control & motor coasts to a stop.
CLOSED allows current to flow in the motor and produce torque.
J1-9 OPEN motor decels or coasts to stop (depending on Keypad Stop mode parameter
setting).
CLOSED operates the motor in the Forward direction (with J1-10 open).
J1-10 OPEN motor decels or coasts to stop (depending on Keypad Stop mode parameter
setting).
CLOSED operates motor in the Reverse direction (with J1-9 open).
J1-11 to Selects programmed preset speeds as defined
J1-14 in Table 3-9.
J1-15 Selects ACC/DEC group. OPEN selects group 1. CLOSED selects group 2.
J1-16 OPEN causes an external trip to be received by control. The control will disable and
display external trip when programmed "ON". When this occurs, the drive is disabled
and an external trip fault is displayed on the keypad display (also logged into the fault
log). If J1-16 is connected, you must set Level 2 Protection block, External Trip to "ON".
J1-39 & Jumper as shown to power the Opto Inputs from the internal +24VDC supply.
40
ANALOG GND
ANALOG INPUT 1
POT REFERENCE
ANALOG INPUT +2
ANALOG INPUT –2
ANALOG OUT 1
ANALOG OUT 2
ENABLE
FORWARD RUN
REVERSE RUN
*
SWITCH 1
*
SWITCH 2
*
SWITCH 3
*
SWITCH 4
ACC/DEC/"S" SELECT 1
EXTERNAL TRIP
OPTO INPUT COMMON
OPTO OUT COMMON
OPTO OUT #1
OPTO OUT #2
OPTO OUT #3
OPTO OUT #4
Terminal Tightening Torque = 7 Lb-in (0.8 Nm).
J1
1 23 A
2 24 A
3 25 B
4 26 B
5 27 INDEX
6 28 INDEX
7 29 +5VDC
8 30
COMMON
9
A
31
10
A
32
11
B
33
12
B
34
13
INDEX
35
14
INDEX
36
15
Not Used
37
16 38
COMMON
17 39
+24VDC
18 40
OPTO IN POWER
19 41
OPTO OUT #1 RETURN
20 42
OPTO OUT #2 RETURN
21 43
OPTO OUT #3 RETURN
22 44
OPTO OUT #4 RETURN
Receiving & Installation 3-31
Encoder
Input
Note 3
Buffered
Encoder
Output
Note 4