Display Screens & Diagnostic Information Access - Baldor 22H series Installation & Operating Manual

Section 1
General Information
Display Mode Continued
Display Screens & Diagnostic Information Access
Action
Apply Power
Press DISP key 6 times
Press ENTER key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
MN722
Description
Display mode showing motor
speed.
Scroll to Diagnostic Information
screen
Access diagnostic information.
Display mode showing control
temperature.
Display mode showing bus
voltage.
Display mode showing %
overload current remaining.
Display mode showing opto
inputs & outputs states.
0=OPEN, 1=CLOSED.
Display mode showing actual
drive running time.
Display mode showing operating
zone, voltage and control type.
Display mode showing continuous
amps; PK amps rating; amps/volt
scale of feedback, power base ID.
Display mode showing which
Group1 or 2 expansion boards
are installed and recognized.
Display mode showing motor
shaft revolutions from the REV
home set point.
Display mode showing parameter
table selected.
Display mode showing software
version and revision installed in
the control.
Displays exit choice.
Display
Logo display for 5 seconds.
No faults present. Local keypad
mode. If in remote/serial mode,
press local for this display.
Diagnostic Access screen.
First Diagnostic Information
screen.
XXXV
Opto Inputs states (Left);
Opto Outputs states (Right).
HR.MIN.SEC format.
Typical display.
ID is displayed as a hexadecimal
value.
Press ENTER to exit diagnostic
information.
Programming & Operation 4-5
Comments