Supermicro X10DRG-O+-CPU User Manual page 91

*If the item above "Confi gure SATA as" is set to RAID, the following items will
display:
Support Aggressive Link Power Management
When this item is set to Enabled, the SATA AHCI controller manages the power
usage of the SATA link. The controller will put the link to a low power state when
the I/O is inactive for an extended period of time, and the power state will return
to normal when the I/O becomes active. The options are Disabled and Enabled.
SATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy
driver for system boot. The options are Legacy, EFI, and Disabled.
SATA/sSATA RAID Boot Select
Select SATA Controller to boot the system from a SATA RAID device. Select
sSATA Controller to boot the system from a S-SATA RAID device. Select Both to
boot the system either from a SATA RAID device or from an sSATA RAID device.
Please note that the option-Both is not supported by the Windows Server 2012/
R2 OS. The options are None, SATA Controller, sSATA Controller, and Both.
Serial ATA Port 0-Port 5
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Port 0-Port 5 Hot Plug
Select Enabled to support Hot-plugging for the selected SATA port which will al-
low the user to replace a device without shutting down the system. The options
are Disabled and Enabled.
Port 0-Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Disabled and Enabled.
Port 0-Port 5 SATA Device Type
Use this item to specify if the SATA port specifi ed by the user should be con-
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
4-21
Chapter 4: AMI BIOS