Supermicro X10DRG-O+-CPU User Manual page 31

X10DRG-O(T)+-CPU/X10DRG-O-PCIE User's Manual
Installing the System Board
1. Install the I/O shield into the chassis.
2. Locate the mounting holes on the motherboard as shown below.
JPB1
J1
JPME2
JBR1
JWD1
JSPK1
JF1
1
JF1
ON PWR RST FAIL PS UID LED NIC 2 NIC 1
3. Locate the matching mounting holes on the chassis. Align the mounting holes
on the motherboard against the mounting holes on the chassis.
4. Install standoffs in the chassis as needed.
5. Install the motherboard into the chassis carefully to avoid damaging board
components.
6. Using the Phillips screwdriver, insert a pan-head #6 screw into a mounting
hole on the motherboard and its matching mounting hole on the chassis.
7. Repeat Step 5 to insert #6 screws into all mounting holes.
8. Make sure that the motherboard is securely placed in the chassis.
Note: Images displayed are for illustration only. Your chassis or compo-
nents might look different from those shown in this manual.
IPMI_LAN
USB5/6(3.0)
VGA
LAN2 LAN1
BMC
LAN
CTRL
JPW21 JPW22
PCH
JBT1
USB2/3
BT1
1
X10DRG-O+-CPU
REV: 1.00
BAR CODE 1G/10G MAC CODE
BIOS LICENSE IPMI CODE 10G SAN MAC
CLOSE 1st
CLOSE 1st
CPU2
OPEN 1st
JPP2
JPP1
LED HDD LED PWR NMI
2-6
JPW23 JPW24
JPW5
I-SGPIO2
I-SGPIO1
CPU1
LD1
OPEN 1st
LD2
JITP1