Supermicro X10DRG-O+-CPU User Manual page 125

X10DRG-O(T)+-CPU/X10DRG-O-PCIE User's Manual
6. After the process of BIOS recovery is completed, press any key to reboot the
system.
7. Using a different system, extract the BIOS package into a bootable USB fl ash
drive.
8. When a DOS prompt appears, enter FLASH.BAT BIOSname.### at the
prompt.
Note: Do not interrupt this process until BIOS fl ashing is completed.
9. After seeing the message that BIOS update is completed, unplug the AC
power cable from the power supply to clear the CMOS, and then plug the AC
power cable into the power supply again to power on the system.
10. Press <Del> continuously to enter the BIOS Setup utility.
11. Press <F3> to load default settings.
12. After loading default settings, press <F4> to save the settings and exit the
BIOS Setup utility.
C-4