Supermicro X10DRG-O+-CPU User Manual page 66

X10DRG-O(T)+-CPU/X10DRG-O-PCIE User's Manual
tings in the IPMI to make sure that the CPU and system temperatures are
within the normal range. Also check the front-panel Overheat LED is not on.
5. Adequate power supply: Make sure that the power supply provides adequate
power to the system. Make sure that all power connectors are connected.
Please refer to our website for more information on minimum power require-
ments.
6. Proper software support: Make sure that the correct drivers are used.
B. When the system becomes unstable before or during OS installation, check
the following:
1. Source of installation: Make sure that the devices used for installation are
working properly, including boot devices such as CD/DVD disc.
2. Cable connection: Check to make sure that all cables are connected and
working properly.
3. Using minimum confi guration for troubleshooting: Remove all unnecessary
components (starting with add-on cards fi rst), and use minimum confi guration
(with a CPU and a memory module installed) to identify the trouble areas.
Refer to the steps listed in Section A above for proper troubleshooting proce-
dures.
4. Identifying bad components by isolating them: If necessary, remove a compo-
nent in question from the chassis, and test it in isolation to make sure that it
works properly. Replace a bad component with a good one.
5. Check and change one component at a time instead of changing several
items at the same time. This will help isolate and identify the problem.
6. To fi nd out if a component is good, swap this component with a new one to
see if the system will work properly. If so, then the old component is bad.
You can also install the component in question in another system. If the new
system works, the component is good and the old system has problems.
3-4