Maintenance" Tab - Roland DWX-4W User Manual

"Maintenance" Tab

In this tab, you can perform operations related to maintenance, including automatic correction of the milling machine and
system reporting. When more than one machine is connected, the machine selected in the top window becomes the target
for the operations.
Daily maintenance
Correction
Move
ATC
Coolant
Spindle
Report
Perform collet and spindle maintenance before starting daily operations.

P. 23 "STEP 0: Spindle Run-In (Short)"
Perform corrections to correct the rotary axis position. You can usually use "Automatic correction. "

P. 39 "Milling Machine Correction", P. 11 ""Manual correction" Dialog Box"
Move the spindle unit and rotary axis. This function is used for cleaning and when repacking
the machine.

P. 34 "Cleaning after Milling Finishes", P. 59 "Attaching the Retainers"
Perform operation tests, maintenance, and other tasks that use the ATC magazine. If the milling
bur is caught on the workpiece and the machine has stopped, you can forcibly release the milling
bur by clicking [Emergency release] (enabled when the power is on with the front cover open).

P. 45 "Milling Bur Change Test", P. 36 "Care of the Dummy Pin for Milling"
Use this function to reset the coolant work time and to drain all of the coolant inside the machine.

P. 55 "Draining the Coolant Lines"
Displays the total work time of the spindle and can be used for long-term spindle management
such as run-in when the spindle has not been used for a long time.

P. 57 "Spindle Run-In (Long)"
You can use these buttons to create reports such as machine system reports (including firmware
version and total operating hours) and error reports. The various reports can be saved as files.
VPanel Window
1. Operation Screen
9