Starting Milling; Milling Precautions; Step 0: Spindle Run-In (Short) - Roland DWX-4W User Manual

Starting Milling

Milling Precautions

Do not turn the power off during the following operations or stop work before the operation is complete.
 Collet maintenance (P. 28)
 Milling (P. 25)
 When the machine is operating after you click the [Emergency release] button (P. 9)
If you turn the power off during these operations or stop work before the operation is complete, the spindle unit may be
in a state where it does not hold anything (the milling bur and detection pin may also be in states where they do not hold
anything). Note that the machine may malfunction in this state.

STEP 0: Spindle Run-In (Short)

Be sure to perform the following tasks before daily operations. These tasks are necessary for maintaining a favorable machine
condition and for ensuring a high level of product quality. If these tasks are not executed, a message prompting operation
will be displayed in VPanel.
Procedure

Show VPanel.
 P. 5 "Displaying VPanel"



Select a machine to operate.
Click the radio button to the left of the name of
the machine to operate.
Click in the top window.
The [Settings] screen will appear.
Click the [Maintenance] tab.
Click [Spindle run-in (short)].
Click [OK].
Spindle run-in will begin.
The machine status light will flash blue. The re-
maining work time will be displayed on VPanel.
23
2. Milling