C.out Configuration Of Two-Step Or Three-Step Output - Samson Trovis 6493 Mounting And Operating Instructions

3.5.10C.OUT Configuration of two-step or three-step output

This function enables you to select a two-step or three-step output. The active two-step output is
easily identified by the
put, whereas the
Note!
Selecting one of these settings has priority over the settings in the B.OUT functions (see secti-
on 3.5.11, as well as over LIM1 and LIM2 (see section 3.6).
When configuring a three-step output, the functions of the binary outputs or limit relays can-
not be used! When configuring a two-step output, you may use the functions of the binary
output BO2 or the limit relay L2.
Choose between:
oFF 2/3S.
g
on 2.STP
g
i.Fb 3.STP
g
E.Fb 3.STP
g
PP 2.STP
g
i.PP 3.STP
g
E.PP 3.STP
g
When accessing the parameter level, all parameters available for output configuration are dis-
played. On the following pages, we will explain which parameters are relevant for which out-
put, so that you only need to define the ones you require.
Note!
On switching over from automatic to manual mode, the relays of the two-step and three-step
outputs are deactivated
In manual mode and with the Y reading at the bottom of the display, the relay outputs can
be activated using the
icon. For the three-step output, the
icon indicates an active Y– output.
No two-step or three-step output
Two-step output
Three-step output with internal position feedback
Three-step output with external position feedback
Two-step output with pulse-pause modulation (PPM)
Three-step output with internal position feedback and PPM
Three-step output with external position feedback and PPM
and keys.
Functions of the compact controller
icon indicates an active Y+ out-
EB 6493-1 EN
41