Samson Trovis 6493 Mounting And Operating Instructions page 2

Firmware versions 2.03 and 3.03
Modifications of firmware versions 2.03 and 3.03
The latest version of the TROVIS 6493 Compact Controller is equipped with an infrared inter-
face. Apart from setting and operating the controller using the operator keys on the front panel,
the integrated infrared interface allows you to configure, parameterize and operate the control-
ler using the TROVIS-VIEW Configuration and Operator Interface.
The software for both compact controller versions has been upgraded:
4
6493-01 Firmware version 2.03
4
6493-02 Firmware version 3.03.
The measuring range of the reference variable (
the previously determined measuring range of the controlled variable (
IN2, IN2). However, changing the measuring range of the reference variable afterwards
does not result in an automatic adaption of the measuring range of the controlled variable (see
section 3.3.1).
Automatic adaption in the CLAS function (see section 3.2.5):
The CLAS function enables you to assign the signals X and WE to the analog inputs IN1 and
IN2. By default, X is assigned to input IN2, WE is assigned to input IN1. If, however, X is as-
signed to input IN1, WE is automatically assigned to input IN2. So far, WE had to be assigned
manually to input IN2.
The parameter Y.PRE has been added to the PAR function.
This parameter determines the rate action of the output signal (see section 3.1).
2
EB 6493-1 EN
WINT, WINT) is adapted automatically to
IN1, IN1 or