Cushman HAULER 800 2012 Technician's Repair And Service Manual page 77

ELECTRONIC SPEED CONTROL - HAULER 800 - TCT
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Pedal bracket
rest against front
of pedal frame
opening
Lock Nut
Use 7/32" drill
to measure gap
between plunger
and 'ITS'
Plunger
1
PEDAL UP
Micro switch
disengaged
'ITS'
To adjust plunger:
- Loosen lock nut
- Rotate plunger until
desired dimension Is
achieved
- Tighten Lock Nut
Fig. 11 ITS Adjustment (Sheet 1 of 2)
Repair and Service Manual
2
PEDAL PRE-TRAVEL
Micro switch
disengaged
Plunger has
not entered
'ITS'
B
B
Page F-11