Cushman HAULER 800 2012 Technician's Repair And Service Manual page 195

Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
HOW TO USE THE HANDHELD PRO-
GRAMMER
The Curtis handheld Programmer is used for program-
ming, testing, troubleshooting, tuning, diagnosing and
parameter adjsutments for speed controller and auxiliary
devices.
Display Screen
Navigation
Key
Power Cord
Fig. 1 Curtis Handheld Programmer
A cable interface is used with all Curtis Controller. E-Z-
GO utilizes a 4 pin Molex or a Molex to Tyco adaptor for
vehicle diagnostic port.
Plug the Curtis handheld programmer into Cur-
tis programmer port only. If plugged into the
wrong port, voltage from other interface cir-
cuits may result in permanent damage to the
programmer.
Handheld programmer will not work when Run-Tow switch is in
the Tow position and also when the battery charger is con-
nected to the vehicle.
The main menu appears after the data is uploaded from
the unit (controller, charger etc), the main menu will not
be displayed if there are no entries within a menu.
PRIMARY CONNECTION: 4 PIN TYCO
• Located under passenger seat.
• Remove protective water cap.
• Use both harness adapters.
• Align white dots on connector.
• Engage and twist sleeve to secure .
Data Increase
or
Data Decrease
Key
Bookmark
Key
Repair and Service Manual
HANDHELD DIAGNOSTICS
ALTERNATE CONNECTION: 4 PIN MOLEX
• Located under controller cover.
• Remove cover for access.
• Use single molex harness.
• Locate 4 pin molex on controller.
• Push molex pin into controller.
NAVIGATION
A blinking square on the left edge indicates the position
of the cursor and the blinking square moves up or down
when up or down navigation key is pressed. Press down
the right arrow on the navigation key to display a column
of sub-menus and again press down the right arrow for
more than one level of sub-menus to be displayed.
B
Page Q-1