Cushman HAULER 800 2012 Technician's Repair And Service Manual page 190

WEATHER PROTECTION
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
B
FULL WINDSHIELD
Tool List
Plastic faced mallet......................................................1
Wrench, 7/16" ..............................................................1
Phillips screwdriver ......................................................1
Remove protective covering from the windshield (2)
(Ref. Fig. 3).
Page P-4
Install sash (3) on each side of the windshield. Using a
plastic faced mallet, gently tap sash to ensure wind-
Qty.
shield seats properly (See Detail A).
Insert screw (4) through washer (5), rubber grommet (6)
and existing hole in front strut. Secure with washer (5)
and lock nut (7) (See Detail B). Do not over-tighten or
squeeze grommet.
Place bottom section of windshield on rubber grommets
and press the sash, starting at the bottom, onto the front
strut so that it snaps into place (See Details B and C).
Repeat for opposite side of windshield.
DETAIL B
2
6
5
4
Front of Vehicle
Fig. 3 Full Windshield
Repair and Service Manual
Windshield
3
DETAIL A
7
5
Windshield
Strut
DETAIL C
3
3