Adjusting The Registration Of The Trays - Savin SLP 38c SLP38C SLP38C Maintenance Manual

Adjusting the Registration of the Trays

You can adjust the registration of
each tray. The vertical adjustment is
used for all trays. Normally, you need
not update the registration. But when
the optional Paper Feed Unit or the
Duplex Unit is installed, updating the
registration is useful in some cases.
The following procedure describes
how to adjust Tray 3. You can use the
same procedure to adjust the other
tray as well.
A
Press { { { { Menu} } } } .
On Line Menu
Job Reset Form Feed
Power Error
"Menu" appears on the panel dis-
play.
B
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display
"Maintenance", and then press
{ { { { Enter} } } } .
Menu:
Maintenance
C
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "Reg-
istration", and then press { { { { Enter} } } } .
Maintenance:
Registration
D
E
Escape
#
Enter
Data In
ZDJS001N
Adjusting the Registration of the Trays
Print the test sheet to preview the
settings.
A Confirm that "Test Sheet" is dis-
played, and then press { { { { Enter} } } } .
Registration:
Prt. Test Sheet
B Press { { { { U U U U } } } } or { { { { T T T T } } } } to display the
tray to adjust, then press { { { { Enter} } } } .
Prt. Test Sheet:
Tray 3
Confirm the position of the image
to test sheet, and then adjust the
registration value.
The following are examples for ad-
justing the margin on the test sheet.
A Press { { { { Escape} } } } .
B Press { { { { U U U U } } } } or { { { { T T T T } } } } to display the
"Adjustment", and then press
{ { { { Enter} } } } .
Registration:
Adjustment
2
43