SATO GT 410 Operator's Manual page 88

Unit 5: Troubleshooting
NO PRINTED IMAGE
No voltage output.
Damaged print head.
Damaged electronics.
Interface problems.
Data input error.
LCD FIELD ILLUMINATED BUT WITHOUT WORDS OR NO DISPLAY AT ALL
Power cable issues.
Incorrectly positioned display potentiom-
eter.
Defective power supply.
MEANDERING MEDIA
Incorrectly loaded media.
Improperly adjusted media guides.
Unbalanced print head.
Worn or improperly adjusted platen roller. Adjust. Replace as required.
PRINTER CREATES A BLANK LABEL
Data input error.
Improper media selected.
Disconnected print head.
Defective print head.
Defective main board.
INCORRECT LABEL POSITIONING
Incorrect sensor selection.
Improper sensor adjustment.
Incorrect media in use.
Data input error.
SATO GTxxe Series Operator Manual
Test power supply and replace as necessary.
Replace print head.
Replace circuit board.
Check. Refer to relative instructions below.
Ensure correct data stream.
Ensure properly connected. Ensure not defective.
Adjust as required.
Troubleshoot and replace components as necessary.
Ensure correct loading.
Adjust as required.
Adjust as required.
Ensure correct data stream.
Ensure correct media is in use.
Cycle off power and ensure proper connection.
Replace print head as required.
Replace main board as required.
Ensure the correct sensor is selected.
Adjust as required.
Ensure the correct media is being used.
Ensure correct data stream.
PN 9001138A Page 5-8