SATO GT 410 Operator's Manual page 64

Unit 4: Operation
MENU
TEST PRINT MODE
CONFIGURATION
BARCODE
HEAD CHECK
MEMORY
FONT
FACTORY
TEST PRINT SIZE
10 mm
TEST PRINT SIZE
LARGE SMALL
TEST PRINT
PRESS ENTER KEY
SATO GT4xxe Series Operator Manual
TEST PRINT MODE (4-11)
Is the premiere screen of the test print mode. To view this
screen and access this mode, press and hold the FEED key
while powering on the printer.
• Configuration: The printer's configuration setting.
• Barcode: The printer's installed barcodes.
• Head Check: A pattern to check print head elements.
• Memory: The contents of the memory cartridge.
• Font: The contents of the installed fonts.
• Factory: A factory test label will be printed.
This screen only appears if Configuration, Barcode, or Head
Check was chosen in the previous menu. The increments of
measurement are 1cm.
For factory test prints, this screen appears instead of the
previous screen for setting print size.
Large (10cm) and small (4cm) print sizes are the only two
options.
Pressing ENTER will initiate continuous test printing. Pressing
ENTER again will suspend printing.
PN 9001138A
DESCRIPTION
Page 4-36