SATO GT 410 Operator's Manual page 60

Unit 4: Operation
MENU
CENTRONICS
FAULT SIGNAL
ON OFF
WIRELESS MODE
802.11 Ad Hoc
Ad Hoc
Infrastructure
SSID
1234567890ABCDEF
CHANNEL
STATUS
REPLY TIMING
ENG CYCLE
LAN
CONFIGURATION
CARD LCD
IP ADDRESS
0. 0. 0. 0
SATO GT4xxe Series Operator Manual
INTERFACE MODES (4-4 THROUGH 4-8)
Allows setting for output timing of fault signal for Centronics
interface. Select ON for synchronous output with Select signal
and OFF with asychronous outputs with Select signal. Will only
display if the Centronics interface is installed.
Allows the selection of the desired communication mode. Will
only appear if mini-LAN interface is present. Will not appear if
Card is selected as the priority. Will become active upon power
reboot.
This display allows setting for SSID of wireless LAN. English
(uppercase/lowercase) and number can be entered up to 32
digits. This display will only appear if wireless LAN is installed.
Will not appear if Card is selected as the priority. Will become
active upon power reboot.
This menu allows channel selection for wireless LAN. This
display will only appear if wireless LAN is installed. Will not
appear if Card is selected as the priority. Will become active
upon power reboot.
01
Allows selection of the timing of returning status data to the
host. ENQ will return the data on status after receiving a status
request (ENQ) from the host. CYCLE will return a status from
the printer to the host at intervals of 500ms. Will only appear
when LAN or wireless LAN is present and if selecting Status 4
for communication protocol.
Allows determination of whether the interface card or the LCD
will take priority presidence. Will become active upon power
reboot.
Allows setting of the IP address. This display will not appear if
any LAN interface is present or Card is not selected in the prior
menu. Will become active upon power reboot.
PN 9001138A
DESCRIPTION
Page 4-32