Advertisement
the same parameter using on Chorus and Tremolo
•FLANGER+TREMOLO
the same parameter using on Flanger and Tremolo
•PHASER+TREMOLO
the same parameter using on Phaser and Tremolo
There are also the following parameters common for each effect type:
•HP/LP Filter: Bypass, 1st and 2nd order Butterworth Filter; frequency from 20Hz to 20kHz step1Hz
•EQ Filter: the single filter can be enabled or disabled using the ON/OFF Button.The filter type is Peak
(BELL), the frequency can be set to a range of 20Hz-20kHz step 1Hz, the Gain of the filter can be change
to a range of +/-12dB and the Q factor of the filter can changed from 0.3 to 20.
Change the Rate value using the BPM Window (after clicking on the BPM button) Beats Per Minute (BPM) to
Frequency (Rate) [Hz]. The modulation frequency (rate) value can be derived from the BPM using the follow-
ing formula:
Freq[Hz] = BPM / (60 * K) (where K depends on the "Note" value as shown in the picture). The BPM range is
limited to the following values:
15 - 120 BPM if "Note" is equal to 1/16
15 - 160 BPM if "Note" is equal to 1/8T
15 - 180 BPM if "Note" is not equal to 1/16 or to 1/8
After selecting the value of the note, select the desired BPM and the value of the rate will be calculated, if the
value is different from the current Rate of the device then the button will blink, the User must click on the button
in order to send the new value to device. Click on the X to close the window.
EFX4: ROOM
•Room Type: Small Rom, Mid Room, Large Room
•Decay: for each room type there are different ranges of the decay value
Small Room: 0.7 - 1.5 sec
Mid Room: 0.7 - 2.5 sec
Large Room: 1.4 - 3.2 sec
Advertisement
