Advertisement
After selecting the "EFX" button, The Edit Process section is updated to display the following:
Here the User can edit all effect parameters.
To edit the value use the same procedure used on the Input Gain.
There are 4 available effects:
EFX1: REVERB
•Density: from 0% to 100%
•Decay: from 0.5sec to 8sec step 0.05sec
•PreDelay: from 0% to 100%
•HP Filter: Bypass, 1st and 2nd order Butterworth filter; frequency from 20Hz to 20kHz step1Hz
•4 EQ Filter: the EQ filters are operative only when the EQ Enable is ON (button orange color).The single
filter can also be enabled or disabled using the relative button ON/OFF.The filter type is Peak (BELL), the
frequency can be set to a range 20Hz-20kHz step 1Hz, the Gain of the filter can be changed to a range of
+/- 12dB and the Q factor of the filter can changed from 0.3 to 20.
•EQ Enable: when disabled (button gray color) the EQ is bypassed and the filter can not edit
EFX2: DELAY
•Delay: from 0 to 680 ms. Change the delay value by clicking the "BPM" Button and modifyning the val
ues in the BPM Window Beats Per Minute (BPM) to Delay [ms]. The delay value can be derived from the
BPM using the following formula: Delay[ms] = (60000 / BPM) * K (where K depends on the "Note" val
ue as shown in the picture). The BPM range is limited to the following values:
89-180 BPM if "Note" is equal to 1/4
133-180 BPM if "Note" is equal to 1/4D
60-180 BPM if "Note" is not equal to 1/4 or to 1/4D
EFX Section
Advertisement
