Displaying And Editing Base Zero Offset - Siemens SINUMERIK 840D sl Operating Manual

Procedure
Note
Further details on work offsets
If you would like to see further details about the specified offsets or if you would like to
change values for the rotation, scaling or mirroring, press the "Details" softkey.
2.7.3

Displaying and editing base zero offset

The defined channel-specific and global base offsets, divided into coarse and fine offsets,
are displayed for all set-up axes in the "Work offset - Base" window.
Procedure
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
The "Work Offset - Active" window is opened.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
3. Press the "Base" softkey.
The "Work offset - Base" window is opened.
4. You can edit the values directly in the table.
Setting up the machine
2.7 Work offsets
63