Siemens SINUMERIK 840D sl Operating Manual page 48

Setting up the machine
2.3 Modes
"REPOS" submode
The "REPOS" submode is used for repositioning to a defined position. After a program
interruption (e.g. to correct tool wear values) move the tool away from the contour in "JOG"
mode.
The distances traversed in "JOG" mode are displayed in the actual value window as the
"Repos" offset.
"REPOS" offsets can be displayed in the machine coordinate system (MCS) or workpiece
coordinate system (WCS).
Selecting "Repos"
"MDA" mode (Manual Data Automatic)
In "MDA" mode, you can enter and execute G code commands non-modally to set up the
machine or to perform a single action.
Selecting "MDA"
"AUTO" mode
In automatic mode, you can execute a program completely or only partially.
Select "AUTO"
"TEACH IN" submode
The "TEACH IN" submode is available in the "AUTO" and "MDA" modes.
There you may create, edit and execute part programs (main programs or subroutines) for
motional sequences or simple workpieces by approaching and saving positions.
48
Press the "REPOS" key.
Press the "MDA" key.
Press the "AUTO" key.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning