3.10.9.2
Panning a graphical representation
Requirement
The simulation or the simultaneous recording is started.
Procedure
3.10.9.3
Rotating the graphical representation
In the 3D view and in the 4-window view, you can rotate the workpiece to view it from all
sides.
Requirement
Simulation is started and the 3D view or the 4-window view is selected.
Procedure
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
1.
Press a cursor key if you want to move the graphic up, down, left, or
right.
1.
Press the "Details" softkey.
2.
Press the "Rotate view" softkey.
3.
Press the "Arrow right", "Arrow left", "Arrow up", "Arrow down", "Arrow
clockwise" and "Arrow counterclockwise" softkeys to change the
position of the workpiece.
- OR -
Keep the <Shift> key pressed and then turn the workpiece in the
desired direction using the appropriate cursor keys.
Machining the workpiece
3.10 Simulating a machining operation
127