Contour Call - Cycle62 - Siemens SINUMERIK 840D sl Operating Manual

Procedure for deleting a contour element
4.8.6

Contour call - CYCLE62

Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
● Contour name.
● Labels; the contour is in the same program bracketed by labels.
● Subprogram; the contour is in the same subprogram.
● Labels in subprogram; the contour is in the same subprogram bracketed by labels.
Procedure
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
1. Place the cursor on the contour element that you want to delete.
2. Press the "Delete element" softkey.
3. Press the "Delete" softkey.
1. Select the part program to be edited in the "Program manager"
operating area.
2. Press the "Open" softkey or the "INPUT" key to edit the part program
in the editor.
3. Press the "Milling" and "Contour milling" softkeys.
4. Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
5. Assign parameters to the contour selection.
Programming a cycle
4.8 Contour milling
259