Line Position Pattern - Holes1 - Siemens SINUMERIK 840D sl Operating Manual

Programming a cycle
4.4 Drilling
Parameter
Parameter
LAB
PL
X0
Y0
X1
Y1
X2
Y2
...
X8
Y8
1) Parameter description refers to plane G17; plane selection G18 or G19 possible in selection field
(MD 52005: $MCS_DISP_PLANE_MILL)!
4.4.8.3

Line position pattern - HOLES1

Function
In the "position pattern" cycle you can program the following patterns in the selection option
in the "Position pattern" parameter.
● Line
● Grid
● Frame
172
Description XY(without A/ or B axis support)
Repeat jump label for position
Machining plane:
1)
G17 (XY)
X0: 1st position (abs)
Y0: 1st position (abs)
X1: 2nd position (abs inc)
Y1: 2nd position (abs inc)
X2: 3rd position (abs inc)
Y2: 3rd position (abs inc)
...
X8: 9th position (abs)
Y8: 9th position (abs)
In the "Line" selection option you can program any number of positions at equal distances
along a line.
You can use the "Grid" selection option to program any number of positions spaced at an
equal distance along one or several parallel lines.
If you want to program a rhombus-shaped grid, enter angle αX or αY.
You can use the "Frame" selection option to program any number of positions spaced at
an equal distance on a frame. The spacing may be different on both axes.
If you want to program a rhombus-shaped frame, enter angle αX or αY.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
Unit
mm
mm
mm
mm
mm
mm
mm
mm
HMI sl Turning