Siemens SINUMERIK 840D sl Operating Manual page 51

Proceed as follows
See also
Default settings for manual mode (Page 77)
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
Machine manufacturer
Please also refer to the machine manufacturer's instructions.
1. Select "JOG" or "AUTO" mode in the "Machine" operating area.
2. Press the menu forward key and the "Settings" softkey.
A new vertical softkey bar appears.
3. Press the "Switch to inch" softkey.
A prompt asks you whether you really want to switch over the unit of
measurement.
4. Press the "OK" softkey.
The softkey label changes to "Switch to metric".
The unit of measurement applies to the entire machine.
5. Press the "Switch to metric" softkey to set the unit of measurement of
the machine to metric again.
Setting up the machine
2.4 Settings for the machine
51