Table of Contents
Advertisement
Note
For a direct connection to DIGSI with interface RS232 jumper X11 must be plugged in position 2-3.
RS485 Interface
The following figure shows the location of the jumpers of interface RS485 on the interface module.
Interface RS485 can be modified to interface RS232 and vice versa, according to Figure 3-12.
Figure 3-13
Profibus/DNP Interface
Figure 3-14
Location of the jumpers for configuring the terminating resistors of the active electrical module (PROFIBUS
and DNP 3.0 interface)
EN100 Ethernet Module (IEC 61850)
The Ethernet interface module has no jumpers. No hardware modifications are required to use it.
SIPROTEC, 7VK61, Manual
C53000-G1176-C159-3, Release date 05.2009
Position of terminating resistors and the plug-in jumpers for configuration of the RS485 inter-
face
Mounting and Commissioning
3.1 Mounting and Connections
201
Advertisement
Table of Contents
