Section 7: Start-Up Sequence - Montigo H38SVO-ST Series Installation & Maintenance Manual

Section 7: Start-up Sequence

A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Q
Do not touch any electrical switch; do not use any
Q
phone in your building.
Immediately call your gas supplier from a neighbour's
Q
phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the Fire
Q
Department.
1. STOP! Read the safety information above on this label.
2. Lift out the lower Horizontal access panel.
3. Push in gas control knob and turn clockwise
4. Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas, STOP! Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5. Locate pilot burner (See illustration at right.) and follow steps
below.
6. Turn knob on gas control counter clockwise
7. Push in gas control knob completely and hold. Light with
NOTE: Gas control knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
1. Turn off remote switch.
2. Lift out the lower Horizontal access panel.
12
Standing (Continuous) Pilot Ignition
with American Flame Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
Lighting Instructions:
to "OFF."
to "PILOT."
To Turn Off Gas To Appliance:
(SIT NOVA 820)
WARNING
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
Piezo Igniter button. Continue to hold the control knob in
for about (1) minute after the pilot is lit. Release the knob
and it will pop back up. Pilot should remain lit. If it goes out
repeat steps 3 through 8.
If knob does not pop up when released. Stop and
Q
immediately call your service technician or gas
supplier.
If the pilot will not stay lit after several tries, turn
Q
the gas control knob to "OFF" and call your service
technician or gas supplier.
8. Push in gas control knob and turn counter-clockwise
to "ON."
9. Replace the lower Horizontal access panel.
10. Turn on remote switch to ignite fire.
3. Push in gas control knob slightly and turn
to "Off". Do not force.
4. Replace the lower Horizontal access panel.
Installation
clockwise
XG0817