Montigo H38SVO-ST Series Installation & Maintenance Manual page 13

A. This appliance is equipped with an ignition system that
lights the pilot burner automatically. Do not attempt to
light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
What To Do If You Smell Gas:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbour's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the Fire
Department.
1. STOP! Read the safety information above on this label.
2. Flip down the lower trims.
3. Turn switch on the gas control to OFF".
4. Wait 5 minutes to clear out any gas. If you smell gas,
STOP! Follow "B" in the safety information above on this
label. If you don't smell gas, go to the next step.
5. Turn switch on the gas control to "ON". NOTE: This unit
is equipped with an ignition system that lights the pilot
burner automatically. Do not attempt to light the pilot
by hand.
6. Turn on wall switch.
1. Turn off remote switch.
2. Flip down the lower trim.
XG0817
Honeywell Electronic Ignition
with American Flame Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
Lighting Instructions:
To Turn Off Gas To Appliance:
WARNING
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified service
technician. Force or attempt to repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the con-
trol system, and any gas control which has been under
water.
7. Flip up the lower trim.
8. If the fireplace does not operate, follow the instructions
"To Turn Off Gas To Appliance" and call your service tech-
nician or gas supplier.
Gas
Inlet
Gas Control Switch
Shown in 'ON' Position
3. Turn the switch on the gas control to "Off".
4. Flip up the trim.
Installation
13