Drive Shaft Reassembly - Suzuki GS1100G 1982 Service Manual

SERVICING ENGINE 3 4 8
*
DRIVE SHAFT REASSEMBLY
Before installing the shaft and gears, wash them
in
a
cleaning solvent.
Mount the 1st driven gear, washer and circlip
on the drive shaft.
Always
use new
circlip.
Apply SUZ UKl Moly Paste to the drive shaft
spline lightly.
Mount the 4th driven
near.
99000
- 251
40
. A
a Mount the circlip
and washer @
on the drive
sha.ft.
Temporarily position the circlip
0
beyond the
groove.
Always use new circlip.
SUZUK I Moly Paste
m
Align the hole in the spacer with the oil hole in
the drive shaft, and install
the
3rd driven
gear.
Mount the lock washer and washer,
on
the drive
shaft, in that order, and by turning the washer in
or out,
align the lock washer tongue with the
cut on
the washer.
Fit the circlip
0
in the groove on the drive-
shaft.
Take special
care so
that the circlip
@
is correct-
ly installed.
Fit it to the side where the thrust is as shown in
the figure.
Mount the 5th driven gear and 2nd driven gear.