Table of Contents
Advertisement
7-5 ELECTRICAL SYSTEM
IGNITER UNIT
Remove the
spark plugs
from Nos. 1 and
2
cylinders. Install the respective plug caps and place the
spark
plugs on
the cylinder head.
Remove the frame cover on the left side and disconnect the
read
wire from the signal generazor.
Turn the ignition switch ON.
First, check the
No.1
spark plug.
Connect
@
pin of SUZUKl Pocket Tester
( X t n
range)
with Blue lead wire on the transistor unit side
and @ pin with Yellow lead wire.
The transistor unit is in good condition if the following is observed:
The
moment the
test pins are connected the spark plug of
No.1
cylinder
sparks.
Next, check the No.2 spark plug.
Connect @ pin of SUZUKl Pocket Tester ( X I 0 range) with Green lead wire on the transistor unit side
and @ pin with Black lead wire.
-
-
. - . . -.
-
-
NOTE:
This checking presupposes that the ignition mil u d for checking i s
a
good
one.
09900
-
25002
Pocket tester
Advertisement
Table of Contents
