Attach A Protective Tube For The Signal Connector - Siemens SIMOTICS M-1PH8 Operating Instructions & Installation Instructions

Electrical connection
6.4 Auxiliary circuits
CAUTION
Modifying the cable outlet direction
Changing the cable outlet direction by any improper means will damage the connecting
cables.
The permissible rotation range must not be exceeded. A maximum of ten changes to the
rotation angle of the Sensor Module are permissible within the rotation range.
6.4.6

Attach a protective tube for the signal connector

A protective tube is supplied as special fastener when removing the signal connector. Slide
the protective tube to remove the signal connector over it and screw it down firmly.
Operation without special fastener is not permissible.
Figure 6-6
Figure 6-7
70
Slide the protective tube to remove the signal connector over the signal connector
Screw the protective tube to remove the connector to the end position
Operating Instructions 05/2012 A5E03986435A AA
SIMOTICS M-1PH8