Table 4-2 Tightening Torque For Rotor Shipping Brace - Siemens SIMOTICS M-1PH8 Operating Instructions & Installation Instructions

Preparations for use
4.11 Transport and storage
Lifting force-ventilated motor in type of construction IM V5 with side-mounted terminal box
Proceed as follows if you wish to lift a machine with type of construction IM V5 and with side-
mounted terminal box:
1. Screw off the external fan.
2. Screw in the eyebolts supplied and use these to lift the machine.
3. Screw on the external fan again after the work has been completed.
Rotor shipping brace
Machines ordered with the "Increased radial force" option are equipped with cylindrical-roller
bearings and a rotor shipping brace.
CAUTION
Transport damage if the rotor shipping brace device is not used.
The motor can be damaged if it is jolted during transport. Material damage can result.
● Always transport the motor with the rotor shipping brace supplied. It must be securely
● Only remove it before pushing on the drive element.
● When the motor has to be transported after the drive element is pushed on you must take
①
②
Figure 4-3
Table 4-2
Type
1PH818.
1PH822.
1PH828.
36
attached during transportation.
other appropriate measures to fix the axial position of the rotor.
Sleeve
Shaft screw
Rotor shipping brace
Tightening torque for rotor shipping brace
Thread in the shaft end
M20
M20
M24
Tightening torque
50 Nm
50 Nm
100 Nm
Operating Instructions 05/2012 A5E03986435A AA
Preload
12 kN
12 kN
20 kN
SIMOTICS M-1PH8