Siemens SIMOTICS M-1PH8 Operating Instructions & Installation Instructions page 69

Figure 6-4
Note
The plug-in connection may differ from the standard layout in the case of special orders. For
versions without speed encoder, connection thread M16x1.5 is located here.
Cable outlet directions
The sensor module is mounted on the motor terminal box. The sensor module can be rotated
through approximately 235°. You can change the cable outlet directions by rotating the sensor
module, as shown in the diagram below.
CAUTION
Damage to the sensor module
You can damage the sensor module if you turn it with a pipe wrench, a hammer, or similar
tools.
Turn the sensor module by hand. The typical torque is approx. 4 ... 8 Nm.
Figure 6-5
SIMOTICS M-1PH8
Operating Instructions 05/2012 A5E03986435A AA
Detailed view: Plug-in connection
①
Sensor Module mounted on the terminal box
Electrical connection
6.4 Auxiliary circuits
69