Fisher & Paykel OR90SDG6 User Manual page 74

PROBLEM
COOKTOP BURNERS
Some burners will not
light.
Flames do not burn all
around the burner
cap.
There is no clicking
when I try to light a
burner.
There is a power failure
– can I still use the
cooktop burners?
The flames have
suddenly gone out.
There is a slight
'extinction pop' or
flash after I've turned a
cooktop burner off.
The burner flames are
uneven, very large,
yellow or yellow-tipped
or sooty.
72
TROUBLESHOOTING
POSSIBLE CAUSES
Burner parts or ignitors may
be wet, dirty, or misaligned.
The ignitor is dirty or there is
a power outage.
Power outage in your area.
A draft or a spill has
extinguished the flame.
Technical fault: the gas is the
wrong type or hasn't been
adjusted properly.
WHAT TO DO
Check that the burner parts
are clean, dry, and correctly
assembled. Check that the
ignitors are clean and dry.
See 'Care and cleaning' for
instructions.
Clean the ignitor(s). See
'Care and cleaning' for
instructions.
The cooktop burners can still
be used. To light them:
1 Holding a lighted
match to the flame
spreader, push in on the
control dial and turn
anticlockwise to LITE.
2 When the flame is
burning all the way
around the burner, you
may adjust the heat.
IMPORTANT!
If the flame is blown out
during a power failure, turn
the dial immediately to O
(OFF), as the burner will not
automatically relight and
gas may escape.
No action required. The
burner will detect this
and automatically relight.
However,
if there has been a large spill,
we recommend turning the
burners off and cleaning the
burners and sump area. See
'Care and cleaning' for
instrucions.
This is normal for LP gas and
requires no action.
Do not use your cooktop
burners. Contact your
Authorised Service Center or
Customer Care.