Fine-Tuning The Origins; Method For Fine-Tuning The Origins - Roland DWX-30 User Manual

4-4 Fine-Tuning the Origins

Method for Fine-Tuning the Origins

On this machine, after detection of the jig location, the origin of each axis is set up automatically. When
you want to adjust the origin of each axis obtained through jig-location detection more exactly, refer to the
method described below.
The method described below is for fine-tuning the Y-axis origin. Use the same method for the other origins
as well.
For information on how to determine the adjustment values of Y-axis and Z-axis origins, refer to the following
section.
Procedure



Move the tool to the Y origin point.
In VPanel, select "Y origin" and click [Move].
P. 57, "Moving to a Specific Position"

Move the Y axis the distance of the adjust-
ment value.
Make the setting for the base point.
Select "Y-origin" and click [Apply].
Chapter 4 Performing Cutting
81