Installation; About Emplacement And Installation; Installation Environment - Roland DWX-30 User Manual

Table of Contents

2-2 Installation

WARNING

The weight of the machine alone is 47 kg (104 lb.). Perform unloading and emplacement with care.

Install in a quiet, stable location offering good operating conditions. An unsuitable location can cause accident,

fire, faulty operation, or breakdown.

WARNING

 Never locate in a location subject to wide fluctuations in temperature or humidity.

 Never install in a location subject to shaking or vibration.

 Never install in a location where the floor is tilted, unlevel, or unstable.

 Never install in a dusty or dirty location, or outdoors.

 Never install in a location exposed to direct sunlight or near air-conditioning or heating equipment.

 Never install in a location exposed to considerable electrical or magnetic noise, or other forms of electro-

magnetic energy.

 Never install in an environment where silicone substances (oil, grease, spray, etc.) are present.

Chapter 2 Installation and Setup

Unloading and emplacement are operations that must be performed by

2 persons or more.

Tasks that require undue effort when performed by a small number of persons

may result in physical injury. Also, if dropped, such items may cause injury.

Install in a location that is level and stable.

Installation in an unsuitable location may cause an accident, including a fall

or tip over.

Never install in a location exposed to open flame.

Cutting waste may ignite. Powdered material is extremely flammable, and even

metal material may catch fire.

Never install close to any flammable object or in a gas-filled location.

Combustion or explosion may be a danger.

Never install outdoors or in any location where exposure to water or high

humidity may occur.

Doing so may result in fire or electrical shock.

Position so that the power plug is within immediate reach at all times.

This is to enable quick disconnection of the power plug in the event of an emer-

gency. Install the machine next to an electrical outlet. Also, provide enough

empty space to allow immediate access to the electrical outlet.

Table of Contents