Tool Length Measurement - Roland DWX-30 User Manual


Detection pin

Spanner (17mm)
After mounting a tool, also perform [Tool Length Measurement] described on the next page.

Tool Length Measurement

This measures the length of the mounted tool. Make sure to perform this after changing the tool.
Before Tool Length Measurement
Make sure that detection of the jig location has finished. If detection of the jig location has not finished, the
tool length measurement may not be possible.
 P. 67, "Detection of the Jig Location"
Procedure

Mount a cutting tool and close the front covers.
 P. 76, "Installing a Tool"
4-2 Preparation for and Performing Cutting
Insert the tool (optionally available) into
the collet until it makes flush contact.
It is recommended to adjust the amount of exten-
sion of the tool tip to around 30mm. Also, use a
collet and tool of matching diameters.
For a detection pin
About
Be sure to use with the tool flush against the mag-
30 mm
netic area of the collet. Otherwise, detection of the
Tool jig location may fail.
Fully tighten the collet.
Using two spanners, tighten the collet fully. The
appropriate tightening torque is 3.2 N-m (32 kgf-
cm).
Spanner
(10 mm)
Chapter 4 Performing Cutting
77