Nokia 500s Installation Manual page 93

Problem Entered wrong password.
Solution Obtain a valid password or set the password to a default value.
Note
You must have local serial access to your appliance console to perform
this procedure. With a keyboard and monitor directly connected to the
appliance, the boot: prompt does not appear, and you cannot perform this
procedure.
To reset the admin password to a default value
1. Boot up the appliance in single-user mode by restarting or power cycling
2. After the appliance boots up, the following text appears:
3. Type
4. The admin password defaults to no password for admin.
5. Enter the following command to reset the password from the command
Nokia 500s Installation Guide
the appliance.
When the boot: prompt appears, enter
multiuser mode; you have about 10 seconds to do this.
Enter pathname of shell or RETURN for sh:
Press Enter.
at the pound-sign (
/etc/overpw
When the response asks if you want to continue, type
Continue to boot to multiuser mode.
line by using a blank password:
dbpasswd admin newpassword ""
The two double quotation marks at the end of the command properly
indicate a blank password.
General Troubleshooting Information
before the appliance goes into
-s
prompt.
#)
.
y
93