Nokia 500s Installation Manual page 118

8
Installing and Replacing Other Components
The two sets of connectors should be aligned with each other. The four
screw holes and four standoffs should also be aligned with each other.
6. Push down on the card until it is properly seated on the motherboard.
7. Place the screws through the standoff holes on the card and into the
standoffs on the motherboard.
8. Turn each screw clockwise to attach the card to the standoffs.
Make sure that all four standoff connections are properly aligned before
tightening the screws completely.
9. To secure the connections, tighten the screws firmly, but do not
overtighten.
10. Slide the chassis assembly back into the appliance and resecure the four
retaining screws.
Reseating the chassis assembly automatically restores power to the
appliance.
11. Configure your software to use hardware acceleration by following the
instructions in
118
Screw
Accelerator card
Standoff hole
Motherboard standoff
"Installing a Fan Unit" on page 119.
Nokia 500s Installation Guide