8
Installing and Replacing Other Components
4. Gently pull the hard disk drive forward to remove it from the appliance.
5. Insert the new hard disk drive until it locks into place.
The ejector and locking lever clicks into the locked position.
6. Tighten the retaining screws on both sides of the hard disk drive.
7. Press the hot swap button to restore power to the hard disk drive.
The 500s appliance recognizes the new hard disk drive.
8. Use Nokia Network Voyager to implement disk mirroring.
Replacing or Upgrading Memory
The Nokia 500s appliance has four dual inline memory-module (DIMM)
sockets. This section describes how to upgrade or replace the memory by
using a Nokia-approved memory upgrade kit.
The 500s appliance comes with 1 GB of memory in two 512 MB DIMMs and
can be upgraded to a maximum of 2 GB of RAM.
Nokia products only support memory kits purchased from Nokia or Nokia-
approved resellers. For further information, contact the appropriate Nokia
customer support site listed in
108
"Nokia Contact Information"
Nokia 500s Installation Guide
00483
on page 3.