Table of Contents
Advertisement
CDD-880 Multi Receiver Router
Ethernet-based Remote Product Management
6.3.3.3
Configuration | Network Pages
Use the nested Network pages to configure network-based operating parameters. Click the
Routing, ARP, Assoc. CTOG, or Working Mode tab to continue.
6.3.3.3.1
Configuration | Network | Routing
When operating a network in Bridge Point-to-Multipoint (BPM) mode, user traffic
will pass through the various traffic ports; however, you must manage the network
through the routed Management Network.
Use this page to enter static routes for IP traffic over the satellite or to another device on the
LAN.
Location of 880
This setting is important for Single Hop On Demand (SHOD) operation.
Use the drop-down list to set the location of the CDD-880 as Hub or Remote. Click [Submit] to
save.
Add New Route
Use this section to directly add a route. From left to right:
Figure 6-15. Configuration | Routing | Routes Page
6–26
MN-CDD880
Revision 2
Advertisement
Table of Contents
