Brother KE-430HX Service Manual page 29

Initial values for each specification
No. KE-430HX -01
260 -23
261 37
262 37
263 37
264 0
265 35
266 35
No. Setting range
OFF, 1 – 99
267
(stitches)
268 0 − 2
269 0 − 2
270 0/1
271 ON/OFF
272 ON/OFF
273 ON/OFF
KE-430HX -03
KE-430HS -03
-23
37
37
37
0
35
35
Initial
Setting units
value
OFF 1
1 1
430H: 0
1
438H: 1
1 1
OFF -
OFF -
OFF -
KE-430HX/KE-430HS, BE-438HX/BE-438HS
KE-430HX -05
KE-430HX -0K
KE-430HS -05
-23
42
37
37
25
35
0
Setting details
If the overall feed timing (setting No. 260) has been changed
from the initial value, this specifies the effective number of
stitches.
OFF: No limit
1 – 99: When the specified number of stitches from the sewing
start is exceeded, the feed timing returns to the
standard timing.
Changes the overall feed timing reference.
0: [Feed start reference] Makes the timing uniform at the start of
feed.
1: [Needle up reference] Changes the timing at the start of feed
so that the feed moves half the feed width when the needle
bar is at its highest position.
2: [Feed end reference] Makes the timing uniform at the end of
feed.
Changes the feed timing reference for the first three stitches at
the sewing start.
0: [Feed start reference] Makes the timing uniform at the start of
feed.
1: [Needle up reference] Changes the timing at the start of feed
so that the feed moves half the feed width when the needle
bar is at its highest position.
2: [Feed end reference] Makes the timing uniform at the end of
feed.
Moving method to the sewing start point after the program is
changed
* However, operation for the "0" setting is always carried out
when No. 273 is set to ON.
0: Moves to sewing start position and then stops.
1: Home position detection is carried out, then moves to the
sewing start position and stops.
Work clamp/button clamp standby position
ON: For the 430H, the center of the sewing area is the standby
position (escape point).
For the 438H, the front is the standby position (escape
point).
OFF: The sewing start position becomes the standby position.
Reduced feed noise
ON: Enabled (Operating speed is limited to 2500 sti/min.)
OFF: Disabled
Start switch operation after program is changed
ON: Moves to sewing start position and sewing starts (program
No. illuminates)
OFF: Only moves to sewing start position (program No. flashes)
4. FUNCTION SETTINGS
BE-438HX
BE-438HS
-23 2
37 -88
37 -58
37 -58
0 0
35 15
35 15
18