Brother KE-430HX Service Manual page 26

4. FUNCTION SETTINGS
Initial values for each specification
No. KE-430HX -01
151 800
152 1200
153 2500
154 3300
155 3300
156 3300
157 3300
158 3300
159 2700
No. Setting range
161 ON/OFF
162 ON/OFF
430H: 1200 − 3300
(sti/min)
163
438H: 1200 − 2800
(sti/min)
164 ON/OFF
-20 − 20
165
(degrees)
10 − 500
166
(ms)
167 ON/OFF
OFF，1 − 120
168
(seconds)
30 − 89
169
(degrees)
430H: 0 − 2800
(sti/min)
170
438H: 0 − 2300
(sti/min)
171 ON/OFF
15
KE-430HX -03
KE-430HS -03
800
1200
2500
3300
3300
3300
3300
3300
2700
Setting
Initial value
units
OFF -
OFF -
3300
100
2800
OFF -
0 1
150 10
OFF -
OFF 1
45 1
0 100
ON -
KE-430HX/KE-430HS, BE-438HX/BE-438HS
KE-430HX -05
KE-430HX -0K
KE-430HS -05
1500
2000
2500
3300
3300
3300
3300
3300
3000
Setting details
Effective hammer operation when needle does not pierce
ON: Enabled
OFF: Disabled
Regulation of sewing speed changes due to sewing pitch
changes
ON: Restricted (Sewing speed is fixed at the minimum
speed for the maximum pitch of the sewing data.)
* Set to ON if there may be a problem with sewing
speed changes as a result of pitch changes.
OFF: Not restricted (Sewing speed varies depending on
sewing pitch of the sewing data.)
Sewing speed limit value
* When setting the sewing speed, the speed will be limited
by this value.
Thread trimming operation disallowed
ON: All thread trimming operations are disabled.
OFF: Thread trimming is carried out in accordance with the
sewing data.
Stop position for needle lift by reverse operation
−: Becomes higher
+: Becomes lower
Delay time until reverse operation starts during reverse
operation needle position stop
Servo lock operation
ON: Enabled
OFF: Disabled
Servo lock timer setting
* Enabled when No. 167 is set to "ON".
OFF: No timer operation
1 to 120: Timer operation (1 to 120 secs.)
Servo lock release rotation angle
* Enabled when No. 167 is set to "ON".
Lowers the allowable speed for the sewing pitch by the
amount set.
However, the minimum allowable speed value is 400 sti/min.
Automatic needle lifter operation
ON: If the needle bar is not at the needle up stop position
during work clamp/button
detection, it moves automatically to the needle up stop
position.
OFF: An error is displayed without the needle bar moving
automatically.
(No. 655 can also be used to ignore this sensor.)
BE-438HX
BE-438HS
400 400
800 400
1200 600
2500 900
3300 2800
3300 2800
3300 2800
3300 2800
2700 2800
clamp home position