Brother KE-430HX Service Manual page 164

9. ADJUSTMENT
6
For example, if the standby position
offset is "5"
7 Completion of setting
8
Turn off the power switch, install the shuttle race base, shuttle hook and bobbin case assembly, and then close the
shuttle race base cover.
153
<Standby position>
Press the
so that the hole (5) in the needle hole plate is near the center of the
hole in the thread nipper D assembly (6).
<Nipping position>
Pass the thread through the hole (5) in the needle hole plate and the
hole in the thread nipper D assembly (6), and then press the
key or the
・ The thread trimmer motor will operate in accordance with the
offset value.
・ The offset value will flash after it has been changed.
3966B
(7)
KE-430HX/KE-430HS, BE-438HX/BE-438HS
key or the key (7) to change the offset value
key (7) to change the offset value.
Touch the OK key
When the setting has been completed, press the back
key .
・ The display will return to the adjustment menu
screen.
to confirm the offset value.