List Of Memory Switches (For Technicians) - Brother KE-430HX Service Manual

4. FUNCTION SETTINGS

4-3. List of memory switches (for technicians)

NOTE:
In standard memory switch setting mode which lets you check from the setting screen (refer to "5-3. Memory switch setting
method (for operators)"), the bottom two digits only display memory switch Nos. 00 to 49. The bottom two digits do not display
memory switch Nos. 50 to 99.
Work clamp/button clamp settings (001 − 099)
No. Setting range
001 OFF, 1 − 2
051 ON/OFF
052 ON/OFF
0 − 3000
060
(ms)
070
1 − 2
071
1 − 2
072
1 − 5
11
Initial
Setting units
value
Work clamp/button clamp lift timing when sewing is complete
OFF: Does not lift automatically.
1 1
1: Lifts at the final stitch position.
2: Lifts after moving to the home position.
Work clamp/button clamp operation before moving to the sewing start
position
ON:
OFF -
OFF: The work clamp/button clamp cannot operate vertically before
Work clamp/button clamp operation during pause (split program)
OFF:
ON -
ON:
Time after the work clamp/button clamp drops until the upper shaft
0 10
starts rotating
Type of foot switch used
1 1
1: Foot switch
2: 2-pedal foot switch (option)
Foot switch operating mode
* Enabled when No. 070 is set to "1".
1 1
1: (1st step) Maximum drop → (2nd step) Start
2: (1st step) Drop to intermediate height →
2-pedal foot switch operating mode
* Enabled when No. 070 is set to "2".
1: (Work clamp switch 1st step) Maximum drop, (Start switch) Start
2: (Work clamp switch 1st step) Drop to intermediate height →
1 1
3: (While work clamp switch depressed to 1st step) Work clamp/button
4: (Work clamp switch 1st step) Maximum drop →
5: (Work clamp switch 1st step) Drop to intermediate height →
KE-430HX/KE-430HS, BE-438HX/BE-438HS
Setting details
The work clamp/button clamp can operate vertically even
before moving to the sewing start position.
moving to the sewing start position.
The work clamp/button clamp cannot rise automatically during
a pause (split program).
The work clamp/button clamp can rise automatically during a
pause (split program).
(2nd step) Maximum drop and start
(Work clamp switch 2nd step) Maximum drop, (Start switch) Start
clamp rises, (Start switch) Start
(Work clamp switch 2nd step) Start
(Work clamp switch 2nd step) Maximum drop and start