Disconnecting The Cylinder From The Compressor - Invacare HomeFill Oxygen System User Manual

Invacare® HomeFill® Oxygen System
3. Remove the cylinder and connector fillport covers (if
present).
4. Momentarily push DOWN on the outer ring (sleeve) B
of the connector fillport C until GREEN dots D are
visible to reset the connector.
If the outer ring (sleeve) is in the UP position
(GREEN dots not visible), the connector fillport
will not be able to accept the cylinder fillport E.
Pushing DOWN F momentarily will reset the
connector fillport (GREEN dots visible) to accept
the cylinder fillport.
5. Grasp the cylinder in the area behind the cylinder
fillport.
6. Position the cylinder in the compressor cradle G.
7. Align the cylinder fillport with the connector fillport.
8. Pull UP on the outer ring (sleeve) of the connector
fillport while pushing DOWN on the cylinder to couple
the cylinder fillport into the connector fillport.
The cylinder is properly connected when an
audible "click" is heard.
20
4.4 Disconnecting the Cylinder from the
Compressor
WARNING!
– NEVER use tools of any kind to
connect/disconnect the cylinder and the
compressor. Otherwise, severe injury and/or
damage may occur.
1. Press the compressor power switch A to the Off (O)
position.
2. Grasp the cylinder B in the area behind the cylinder
fillport C.
1100873-M