Connecting The Compressor To The Concentrator - Invacare HomeFill Oxygen System User Manual

Invacare® HomeFill® Oxygen System
1. Choose a proper location. Refer to 3.3 Choosing a
Location, page 14.
2. Make sure the power switch is in the Off (O) position.
3. Plug the power cord into the electric connector A in
the back of the compressor B.
4. Plug the opposite end of the power cord C into the
wall outlet D.
5. Leave a minimum of 3" (7.6 cm) clearance to the power
cord ends for disconnection access.
The power inlet acts as the mains disconnection
device to remove all power to the unit when the
line cord is disconnected.
3.6 Connecting the Compressor to the
Concentrator
16
1. Insert one end of the interconnect hose C into the
outlet fitting B on the back of the concentrator A.
2. Insert the opposite end of the interconnect hose into
the inlet fitting D on the side of the compressor.
The metal tabs E on the concentrator outlet
fitting and the compressor inlet fitting will pop
out with an audible "click" when the end of the
interconnect hose is properly installed.
3. Loop any excess interconnect hose and secure to the
back of the concentrator with the fastening straps.
1100873-M