Table of Contents
Advertisement
monitor
Available after switching to Monitor mode by pressing the [monitor] button on the remote control.
Selects the screen status automatically．
Turns the monitor power on/off．
up/down/Left/right(▲▼_ +)/enter
Moves the cursor up/down/left/right, and runs the
Displays the video screen within a screen．
using the numeric buttons
CHANNEL 1–9
changing the remote control id
1.
Press the ID button of the remote control and check the ID displayed on the DVR screen.
The factory default ID of the remote control is 00.
2.
Enter 2 digits of your selection in order, while pressing the system [id] button.
3.
When ID input is done, press the system [id] button again to check the setting.
M
`
If you want to change the remote control ID to 08: Press 0 and 8 in order while the system [ID] button is pressed.
Remote control's ID and DVR's ID should be matched for proper operation. Refer to "Remote Devices". (Page 45)
00769B_SHR-8162_ENG-NEW.indb 13
auto
p.mode
Selects the screen mode．
power
numBer [0~9]
Changes the system ID.
+/-
Adjusts the audio volume．
menu
Displays the Setup Menu．
Select Menu.
FreeZe
Screen Freeze．
under scan
Press any button among 1 to 9.
id reset
Initializes the ID value to 01.
monitor
Activates the monitor function.
id
Sets the ID.
Select 2 digits from 0 ~ 9 while pressing the ID Key.
mute
Mutes the audio out.
source
Selects the input signal source.
pip
Selects or deselects the PIP function.
English _1
2008-12-04 오전 10:13:40
Advertisement
Table of Contents
