Preset Keys - Furuno CH-500 Operator's Manual

5. MENU OPERATIONS
How to add menu short-cuts to the short-cut keys
To add a menu function as a short-cut, follow the procedure below.
Note: The function key used for this short-cut must be assigned as a [Short-Cut Key].
See section 5.6.1 for details.
1. Press the MENU key. The menu window appears.
2. Press
3. Press
short-cut. The menus which contain function that can be added are: [COM1],
[COM2], [HORI.], [VERT] and [ES].
4. Press
function key. A confirmation message appears.
5. Press the function selected at step 4 again. The function is registered as a short-
cut.
6. Referring to section 5.6.1, access the [FUNC Key] menu and check that the func-
tion is registered.
7. Press the MENU key to close the menu.
Note: When the short-cut setting for a function key is changed to [VERT Search] or
[Delete Mark], menu short-cuts are deleted. To re-register a menu function as a short-
cut, repeat the above procedure.
5.6.3

Preset keys

You can adjust the preset keys suit your needs. To adjust the presets, do the following:
1. Set the display mode, sector, train angle, scan range, tilt angle, scan speed and
gain to the settings you want to store. This will become the preset.
2. Referring to section 5.6.1, access the [FUNC Key] menu.
3. Press the appropriate function key. A guidance message is shown above the
menu.
Note: The selected key must be setup as a [Preset Key]. See section 5.6.1.
4. Press the function key again to store the current display mode settings. The table
below shows the pre-programmed (default) settings for each key.
Menu item
[Key1]
[Key2]
[Key3]
5. Press the MENU key to close the menu.
5-6
to select the menu bar.
or to select the menu which has the function you want to add as a
or to select the function you want to add, then press the appropriate
• Display mode: Horizontal (zoomed)
• Sector setting: 240°
• Train angle: 0°
• Scan range: 160 m
• Display mode: Horizontal
• Sector setting: 360°
• Train angle: 0°
• Scan range: 160 m
• Display mode: Vertical
• Sector setting: 180°
• Train angle: 90°
• Scan range: 120 m
Settings
• Tilt angle: 30°
• Scan speed: 12°
• Gain: 5.0
• Tilt angle: 30°
• Scan speed: 12°
• Gain: 5.0
• Tilt angle: 90°
• Scan speed: 6°
• Gain: 5.0