How To Use The Event Marker; How To Inscribe An Event Mark; How To Delete Event Marks - Furuno CH-500 Operator's Manual

1. OPERATIONAL OVERVIEW
1.14

How to Use the Event Marker

The event marker function marks important locations on the display, and up to five
markers may be inscribed. This function requires connection to speed and positions
sensors. When [TLL Output] is set to [ON], the CH-600 outputs event mark information
to the external navigational equipment such as a gyrocompass, a GPS receiver and
so on. Press
The procedure to inscribe an event mark is the same for all display modes.
1.14.1

How to inscribe an event mark

To inscribe an event mark, move the cursor to the location to mark, then press the
EVENT key
Each time the EVENT key is pressed, the latest event mark icon (
sor location. All previous marks are displayed with the previous event mark icon (
When the capacity for event marks is reached, the oldest mark is erased to make room
for the newest mark.
Note 1: For Horizontal and Full-circle A-scope display modes, the range and bearing
for the latest event mark is displayed at the bottom-left of the screen.
Note 2: Where Horizontal + Cross-Section display mode is in use, event marks can
only be inscribed in the main window.
1.14.2

How to delete event marks

To delete all event markers, do the following:
1. Move the cursor outside the echo display area.
2. Press the EVENT key. All event marks are re-
moved from the display.
1-20
key to output own ship information from NMEA2000 port.
.
Event mark inscribed Event mark inscribed
) appears at the cur-
CSE
SPD
GAIN
TVG LEVEL
DISTANCE
COLOR
).
Echo Echo
display display
CSE
SPD
area area
GAIN
TVG LEVEL
DISTANCE
COLOR